Retro Hemi R/T Graphics Installation

Materials Needed for Application:
1. Application Squeegee (Included with kit)
2. Soft Cotton Towel (Lint-Free)
3. Masking Tape
4. Tape Measure

6. Spray Bottle

A 16 oz. misting bottle is ideal. Add two drops of Joy liquid dish soap and fill with warm water.

1. Clean all surfaces thoroughly using appropriate cleaners. Wax coats should be removed to insure proper adhesion of graphics.
2. Position graphics onto vehicle and align visually. Small pieces of masking tape work best for holding the graphic in place.
3. Apply masking tape vertically in the center of the graphic to act as a hinge. The graphic will be applied in two sections...right and then left.
4. Flip one side of the graphic out of the way.
Using a spray bottle mixture of 16 oz. of water to two drops of Joy liquid detergent soap, spray the entire application area on the vehicle.
5. Remove the release liner from the back of the graphic to expose the adhesive and cut-off cleanly using scissors.
6. Spray the exposed adhesive side with water/joy spray solution. Be sure to saturate entire area.
7. Flip graphic back onto vehicle surface and burnish water/joy solution from under decal.Work from the top down with even strokes and coverage.
8. Repeat steps 4 through 7 for the left side of graphic. Allow entire graphic to set for 15 minutes before proceeding to step 9

Got Questions? Ask The Pro's!

We are pleased to help you with the installation process. Just give us a call and we can guide you through the installation.

1-800-872-4614
9. Slowly remove premask covering to expose the graphic. Pull back at a 180 degree angle. The finished applique will keep its appearance for years.
Back To Home Page